K150 Pic Programmer Software Windows 10 _hot_ <Direct Link>

Right-click the Windows Start menu and select . Expand the Ports (COM & LPT) section.

The K150 is a popular, budget-friendly USB programmer for Microchip PIC microcontrollers, though running it on Windows 10 requires specific workarounds due to aging hardware drivers Driver Challenges & Solutions The K150 typically uses the USB-to-serial chip. www.davidpilling.com The Problem

Once the software recognizes the hardware, follow these steps to flash your microcontroller:

This guide provides a comprehensive walkthrough on downloading the correct software, installing the necessary drivers, and troubleshooting common USB connection issues on Windows 10. 1. Prerequisites: What You Need To use the K150 programmer, you will need: Windows 10 PC. Microblaze PIC Programmer Software (Microbrn). k150 pic programmer software windows 10

Go to Setup → Serial Port . Choose the COM port number assigned to the Prolific device in Device Manager.

Click > Baud Rate and set it to 19200 (this is the default speed for the K150 firmware).

Launch the microPro.exe application. Because of the previous step, Windows will ask for administrator confirmation; click . 1. Connect to the Correct COM Port Right-click the Windows Start menu and select

What are you trying to program?

Look at the screen diagram provided by microPro. It visually demonstrates exactly how to position your chip inside the ZIF (Zero Insertion Force) socket. Ensure the notch of the chip faces the correct direction and lock the lever down.

| Error Message | Cause | Windows 10 Fix | | :--- | :--- | :--- | | “The driver is not intended for this platform” | Trying to install 32-bit driver on 64-bit Windows 10 | Use PICPGM’s WinUSB driver. Do not use the CD driver. | | “USB device descriptor failed” | CH340 chip is counterfeit or driver clash | Uninstall all USB drivers under “Universal Serial Bus devices” in Device Manager, then reinstall CH340 driver. | | “Failed to open device. Access denied.” | Another application (like Arduino IDE) has the COM port locked | Close all serial monitor software. Change COM port number in Device Manager to COM1-COM4. | | “PIC not found. MCLR voltage error.” | Incorrect Vpp voltage or poor connection | Windows 10 USB ports provide 5.0V, but some PICs need 13V. Check your K150’s jumper for external power. Ensure target PIC is powered externally (K150 supplies limited current). | | “Verify failed at address 0x0000” | Timing issue due to Windows 10’s USB polling | In PICPGM, increase the “Delay for Vpp” to 50ms. In WinPic800, reduce communication speed to “Low.” | Microblaze PIC Programmer Software (Microbrn)

The CD that comes with the programmer contains K150.exe and a Driver folder. This software was compiled for Windows 98/XP. It uses a kernel-mode driver that is . Even if you disable driver signing, the application often crashes due to deprecated DLL calls.

If you plug in your K150 and see a yellow triangle in , follow these steps to install the compatible driver:

Select File → Open and load your compiled .hex file.