Use the buttons to choose a destination bank (01 to 60).
Press the Mode button until the Manual indicator is illuminated. You can step through your programmed sequence manually using the bank up/down buttons or assign a static look. Auto Playback (Fader Speed Control) Press the Mode button until the LED lights up. Select your desired chase button.
Press the . All LEDs will flash to confirm the step is recorded. Repeat steps 3 and 4 to add more scenes to the chase.
: Connect the "DMX Out" of the controller to the "DMX In" of the first light fixture. Continue linking from the "DMX Out" of one fixture to the "DMX In" of the next.
Ultimate Guide and Operating Manual for the Disco 240 DMX Controller disco 240 dmx controller manual
Ultimately, the Disco 240 manual serves as a "Quick Start Guide" rather than a comprehensive handbook. It
Stores up to 240 programmable scenes and 6 banks of chases.
MIDI control over banks/chases, built-in microphone for music triggering, and a blackout master button Quick Setup Guide Addressing:
For users just wanting to run pre-programmed "Auto" or "Sound Active" modes, the manual does an adequate job. Use the buttons to choose a destination bank (01 to 60)
These physical sliders adjust the DMX values (0–255) for the selected fixture.
If you’ve just bought one or are struggling with its interface, you’ve come to the right place. This article serves as a comprehensive guide, combining insights from official resources like the and the HD-240 Instruction Manual to answer all your questions.
Select the Scanner and adjust faders to create the first step. Press MIDI/Rec to store the step. Repeat steps 3-4 for up to 240 steps. Exit Program mode by holding the Program button. 5. Running Scenes and Chases Once programmed, you can run your show in several modes.
: Located on the left side. These select which lighting fixtures you are actively controlling. Auto Playback (Fader Speed Control) Press the Mode
Press the buttons (1 to 12) for the lights you wish to position.
A chase is a dynamic sequence made by linking multiple programmed scenes together. You must program your static scenes before compiling a chase.
: Plug the provided power adapter into the DC input (typically 9-12V) and turn on the power switch.