Please check your E-mail!
Please check your E-mail!
Remove the outer plastic cover of the ProSecure Opti Combi by gently releasing the retention clips at the bottom.
: It is recommended to use a weather cap for outdoor applications to prevent interference from rain.
Connect to safety/presence loop input of the door controller
12V to 24V AC ±10%; 12V to 30V DC -5% / +10% Power Consumption: < 3W (VA)
Note: Depending on the specific production series of the Opti Combi, the safety output can be set to Normally Open (NO) or Normally Closed (NC) electronically via dip-switches. 4. Field Adjustments and Programming
This English manual guide details the technical specifications, physical installation, field adjustments, configuration menus, and troubleshooting steps needed to optimize the system. Technical Specifications Specification Details Microwave Radar (24.125 GHz) + Active Infrared (AIR) Mounting Height Maximum 4.0 meters Detection Area Max 4.7m (Width) x 1.7m (Depth) Operating Temp -20°C to +60°C IP Protection Class IP54 (Dust and splash resistant) Compliance EN 16005, DIN 18650 Mechanical Installation and Mounting
Motion relay (Type A) and Safety relay/opto-coupler Temperature Range: -20°C to +55°C (-4°F to 131°F) IP Rating: IP54 (dust and splash-proof) 2. Pre-Installation and Mounting Instructions
: You can modify the size and shape of the detection field using the potentiometer. Settings include "Slow Motion" detection for high-sensitivity requirements. Learning Mode
: Use the provided self-adhesive mounting template to drill holes and secure the base plate. For swing door applications, the sensor should be mounted roughly 20–30 cm above the door edge near the hinges.
Can be adjusted (often Levels 1–5) to account for environmental factors like cross-traffic Field Size:
Q: How do I reset the ProSecure Opti Combi? A: Refer to the manual for instructions on resetting the combi boiler. Typically, this involves pressing a combination of buttons or switches on the control panel.
Do you require troubleshooting for ? Share public link
For detailed wiring diagrams or specific error codes, you can download the full PDF manuals from the dormakaba Download Centre wiring diagram
8–30 V DC (low or high active depending on configuration).
Use a soft, damp cloth. Avoid aggressive cleaning agents that could damage the optical lens
Typically 2.0m to 4.0m (Standard setting is often 2.5m to 3.5m) Detection Speed Minimum 5 cm/s Made-in-China.com Supply Voltage 12V to 24V AC/DC Made-in-China.com Transmitter Frequency 24.150 GHz (Microwave) Made-in-China.com Protection Class Typically IP 54 (suitable for dust and splash protection) Installation & Configuration Essentials
