Hanmatek Dos1102 Manual Free | Chrome |

Press the blue button on the top right of the panel. The scope will automatically configure the timebase and vertical scale. Observe the square wave on the screen: Perfect Square: Your probe is correctly compensated.

: USB Device and Host interfaces for PC communication and U-disk data storage. 2. Initial Setup and Safety

Use the [Measure] menu to display automatic measurements like frequency, peak-to-peak voltage ( Vppcap V sub p p end-sub ), and average voltage.

If you're just getting started, here’s a quick-reference guide to your new scope: Dual Channels : 110MHz bandwidth with a 1GS/s sample rate.

+---------------------------------------------------------+ | [ Display Screen - 7" TFT ] [Utility/Math]| | Buttons | | | | [Horizontal Controls] [Vertical Controls] | | - POSITION (Pan) - POSITION (CH1 / CH2) | | - SEC/DIV (Timebase) - VOLTS/DIV (Scale) | | | | ( CH1 Input ) ( CH2 Input ) ( External Trigger ) | +---------------------------------------------------------+ The Interface Breakdown hanmatek dos1102 manual

Flip the physical switch on the probe handle to 10X .

There is a mismatch between your probe and your oscilloscope software settings. Ensure that if the physical switch on the plastic probe body says 10X , your internal channel menu ( CH1 -> Probe ) is also set to 10X . Factory Reset / Self-Calibration

The Hanmatek DOS1102 manual highlights the oscilloscope's impressive range of features and functions, including:

You can perform operations like , CH1 - CH2 , or CH1 × CH2 . Press the blue button on the top right of the panel

Press the yellow button on the front panel. Look at the menu on the right side of the screen and ensure the Probe setting is manually changed from 1X to 10X to match your physical probe.

| Issue | Description | |-------|-------------| | | No detail on how to set up trigger holdoff or noise rejection. | | FFT section is too terse | No guidance on choosing window types (Hanning, Rectangular) for different signals. | | No example of decoding serial protocols | The DOS1102 does not include serial decode (I²C, UART, SPI) – manual correctly omits it, but users sometimes expect it. | | Translation issues | Awkward phrasing like "Click the knob of the vertical to choose the coupling way." | | No PC software manual | PC software (Hanmatek ScopeView) has a separate, even more minimal document. | | Error in older revisions | Early manuals incorrectly listed memory depth as 40k (actual: 8k/ch). |

Toggle the menu key until it matches your physical probe setting: . Note: If these do not match, your voltage readings will be off by a factor of 10. Step 4: Perform Probe Compensation

Do not exceed the maximum rated input voltage (typically 300V RMS or 400V peak). Environment: Operate only in dry, well-ventilated areas. 2. Front Panel Layout digital oscilloscope Hanmatek DOS1102 user guide : USB Device and Host interfaces for PC

Adjusts the voltage threshold that the signal must cross to trigger a stable display.

Change this setting to match your probe: . If your physical probe is at 10X and the scope is set to 1X, your voltage readings will be incorrect by a factor of 10. Step 3: Compensation Adjustment

Measures the vertical difference between two horizontal bars.

Hanmatek Dos1102 Manual Free | Chrome |

Hanmatek Dos1102 Manual Free | Chrome |

Список драйверов: