The smoke fan is at maximum speed to clear ash during shutdown. 5. Troubleshooting & Alarm Codes
He found the section: Appendix C - Hard Reset Protocol.
Modifying draft based on chimney length. Trigger Temperatures: Changing when fans turn on/off. Conclusion
Gear motor output responsible for dropping pellets into the brazier. IGN: Ignition heating element (spark plug) output. Low Voltage Terminals (Sensors & Displays) micronova es99 user manual verified
A (Verified): "This is normal. The cooling cycle runs for 90 to 180 seconds to dissipate residual heat from the ceramic matrix. Do not unplug the unit during this time."
The smoke extractor fan is not spinning at the required RPM.
To access the technical settings configuration on a standard Micronova display connected to the ES99, follow these steps: The smoke fan is at maximum speed to
Verify that the small silicone tube connecting the pressure switch to the exhaust path is clean and not pinched or cracked. AL6 / AL_SOND — Probe Failure
The exhaust temperature dropped below the minimum threshold during operation, indicating the fire went out.
This enters the settings.
: Its "auto-dual" control reduces idle running to a minimum, significantly lowering electricity costs.
The back of the Micronova ES99 board relies on physical dip-switches to determine high-level operational software parameters. Hardware Architecture
The controller will lower the heat level when the room temperature is close to the target, and increase it when the room cools down. D. Turning the Stove Off Press and hold the button. Modifying draft based on chimney length
The ES99 screen went dark. The text reappeared one last time.