Control Manual [exclusive] | Px-rc1 Remote

Insert 2 new AAA batteries, matching the polarity (+ and -) diagrams inside the compartment. Replace the battery cover.

PX-RC1 Remote Control Manual: Programming, Troubleshooting, and Codes

Point the remote at the device and slowly press the (Channel Up) button repeatedly. This sends a sequence of codes to your device.

Point the remote at the device and press the button. If the device turns off, programming is complete. If not, repeat the steps with a different code. Method B: Auto Code Search

If the device does not respond, repeat the steps using the next code listed for your brand in the code library. Method 2: Auto Code Search Turn on the device you wish to pair with the remote.

Press and release the corresponding to the component (e.g., TV ).

the battery compartment cover located on the back of the remote control.

Insert the batteries, matching the and - marks inside the compartment. Push the battery cover back into place until it clicks.

Use this if you can’t find a specific code for your brand. your device manually.

Most PX-RC1 remotes share a similar layout. Here is the typical button mapping:

To perform a factory reset (clearing all custom codes):

Press and hold the button until the red indicator light glows continuously. Release the button.

Open the back cover. Insert batteries according to the polarity markings (+ and -). models slide the coin cell under the metal clip; AAA models insert both batteries correctly.

Because "PX-RC1" is a common model number used by several Chinese manufacturers for (often sold under brands like PX , HYZ , or generic unbranded packaging), the exact manual layout may vary slightly. However, the programming instructions are standard across nearly all PX-RC1 units.