V2000-c Rfid Access Control User Manual [top] ★ Exclusive Deal

V2000-C Terminal Block ------------------------------------------------ +12V → Power supply positive GND → Power supply negative (common ground) NO → Normally open (to lock’s positive unlock wire) COM → Common (to lock’s negative / power supply GND) NC → Normally closed (rarely used with fail-secure locks) PUSH → Exit button (one side; other side to GND) SEN → Door contact sensor (to GND when door closed) ALARM → Optional alarm output BELL → Optional buzzer output

Enter Programming Mode →right arrow Press 4 →right arrow

To configure the relay, adjust the jumper on J1. The behaviour also depends on how the COM (J3) terminal is configured: V2000-c Rfid Access Control User Manual

Turn off the power supply. Press and hold the # key or the exit button loop while restoring power. Hold for 3 to 5 seconds until you hear a series of short beeps. The programming code will revert to the factory default ( 9999 ). User card data will not be erased during this hardware reset.

The V2000-C is a standalone access control system designed for single-door entry points. As an all-in-one device, it integrates a keypad, an EM (125kHz) RFID card reader, and the main controller board into a single unit. It is ideal for securing offices, homes, warehouses, and other facilities that require controlled access for up to 1000 users. Hold for 3 to 5 seconds until you

Valid card read, valid PIN entry, or successful keystroke.

Security and simplicity rarely go hand in hand, but standalone RFID access control keypads bridge that gap perfectly. The is a popular, weather-resistant standalone controller used globally to secure commercial buildings, residential gates, server rooms, and private offices. The V2000-C is a standalone access control system

The V2000-C is a standalone RFID (Radio Frequency Identification) access control system designed to manage entry to restricted areas (doors, gates, or turnstiles). This report consolidates the critical sections of its user manual, focusing on safety, installation, programming, and troubleshooting.

3.1 Last Updated: [Current Year] Compatibility: All V2000-c hardware revisions H1.2 and above.

Always turn off the 12V DC power supply before splicing any wires to prevent short circuits. Lock Wiring: