After installation, launch the MKS Laser Tool software and follow these steps to configure it:
Easily upload .bin firmware files to the ESP32 chip.
Installation steps: unzip the file if it's a .zip, run the .exe, follow the prompts, configure the software according to the user manual. mks laser tool setup v112exe download link
: Connect your engraver to a local network for wireless control.
Makerbase hosts all official software, tools, and firmware transparently on . After installation, launch the MKS Laser Tool software
Let me start outlining the blog post structure:
Convert standard BMP, JPG, or PNG image files into specialized laser-ready formats. Makerbase hosts all official software, tools, and firmware
Once the software is open, you must configure the connection parameters to interface with your machine. Flashing Firmware If you need to update or reinstall your GRBL firmware: Open MKS Laser Tool and click on the tab. Select your specific board model (e.g., MKS DLC32). Click Browse and locate your firmware .bin file. Select the correct COM Port found in your Device Manager. Set the Baud Rate to 115200 .
A Complete Guide to MKS Laser Tool Setup V1.1.2: Download and Configuration Guide
With the board connected via USB, navigate to the section. Enter your home or workshop WiFi SSID (Name) and Password . Click Connect or Write Configuration .
Navigate to the official ( ://github.com ). Locate the repository named MKS-DLC32 or MKS-Laser-Tool . Click on the Tool or Release folder within the repository.