features a dual-extruder system, allowing for two-color or supporting filament prints. Go to the "Filament" menu. Select "Load" for the desired extruder (Left or Right).
Format SD card to FAT32 with 4096 bytes allocation unit. Card must be 32GB or smaller. Use "Quick Format" only.
Consistency is key. Users report that leveling is straightforward once you develop a feel for the correct resistance.
Ensure the power switch is set to the correct voltage for your region (110V/220V). Plug in the power cable and turn on the machine. 2.2 Leveling the Print Bed (Crucial Step) qidi x-pro manual
Insert the filament through the guide tube into the extruder. Push until you see plastic flowing from the nozzle. Select "Unload" in the filament menu. Once heated, the extruder will reverse the filament. Remove the old spool, load the new one, and select "Load". 5. Slicing and Printing (QIDI Print Software)
Place the dual-extruder assembly onto the X-axis carriage. Secure it using the included screws from underneath the carriage. Plug the main ribbon cable tightly into the top of the extruder block.
Configure print settings (speed, temperature, layer height) and click "Slice". Save: Save the generated G-code file to the USB drive. features a dual-extruder system, allowing for two-color or
Plug the main ribbon cable firmly into the top of the extruder assembly. Step 2: Powering On and Language Selection
Yes, but you will need a . The stock brass 0.4 mm nozzle will wear out very quickly on carbon‑fiber filled filaments. The printer’s all‑metal hotend can reach temperatures sufficient for carbon‑fiber reinforced materials (typically 240–260 °C).
The spool holder is typically installed on the back or side of the printer. 2. Setting Up the QIDI X-Pro Format SD card to FAT32 with 4096 bytes allocation unit
Slide a standard sheet of A4 printer paper between the nozzles and the build plate.
Slice the model and save the gcode file to the USB drive. 5. Printing and Monitoring Insert USB: Insert the USB drive with your sliced file.